The triangular tines can be honed with a file. The fire rake with its three, tempered steel blades and 5-foot handle is traditionally preferred to the McLeod in the eastern states. Can be found at Safety tip: Be aware that each end (blade and tines ) is sharpened. Similar to the McLeod, and made with heavier gauge metal, the Lamberton Rake is a strong dependable tool that can be used to push and pull material and even cut tree roots 3 to 5 inches in diameter. Safety tip: Stand the McLeod on its head instead of flat on the ground when you need to put it aside while working. Carry it with the tines pointing toward the ground, ideally with a sheath over the cutting edge. Because of its shape, the McLeod is an awkward tool to transport and store. It can also be used to shape a trail's backslope. The McLeod is useful for removing slough and berm from a trail and tamping or compacting tread. It was originally intended for raking fire lines with the teeth and for cutting branches and sod with the sharpened hoe edge. The McLeod with its large hoe like blade on one side and tined blade on the other is a forest fire tool common in America's western mountain ranges. To keep the head in place, put a small sheet-metal screw into the handle just below the head. The head should tighten on the handle as the mattock is swung, but sometimes it loosens and slides down the handle. Handles are generally 36 inches long-a good length for almost trailwork. For heavy work, use at least a 5-pound head. Mattocks may be purchased with head weights ranging from 3 to 6 pounds. The other blade of a mattock may be a pick (pick mattock) for breaking or prying small rocks or a cutting edge (cutter mattock) for chopping roots. Safety tip: Picks should not be used as a lever to pry loose large rock.Ī mattock is a heavy sturdy grubbing tool with an adz blade that can be used as a hoe for digging in hard ground. As with any tool used for breaking hard soil or rock, safety glasses should be worn to protect your eyes from flying debris. The tool can be used to break or pry small rocks, loosen heavy soil and gravel, or to dig a trench or hole. The standard pick has a narrow chisel blade on one end and pointed tip on the other. Picks are rarely necessary in trail work, its job being adequately served by the pick mattock. Safety tip: The handle can be removed for ease in packing. They usually come with a 34-inch handle and a 6-inch-wide blade set at an "adze angle" and are maintained and used like a mattock. Grub hoes of various weights are available and are good for building and repairing trail tread and for digging trenches to hold turnpike logs and waterbars. Safety tip: Work with Pulaski in front of you. A sharpened Pulaski should be marked to discourage anyone from mistakenly dulling a Pulaski meant for timber work by using it for digging. With the bit and adz keenly honed, a Pulaski is an excellent woodworking tool for shaping the notches and joints of turnpikes, bridges, and other timber projects. Unlike grub hoes or mattocks the Pulaski is a sharp-edged took, and should not be used in rocky soil. It is preferred by many trail crews for loosening dirt, cutting through roots, or grubbing brush because it is widely available and easier to carry than single-purpose tools. Pulaskiĭeveloped to grub and chop duff during forest fires, the Pulaski combines an axe bit with an adz-shaped grub hoe on a 36 inch wood or fiberglass handle. These are the most commonly used Grubbing and Raking Tools with tips on using them safely and effectively.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |